Iwata 0.2mm Fluid Nozzle for HP-A/B/SB (same as IWS-0801)

Description

Art No: IWS-0802 – Iwata 0.2mm Fluid Nozzle for HP-A/B/SB (same as IWS-0801)

Important Note: Never remove the nozzle unless it is already damaged. If you thoroughly clean the airbrush, this will prevent the nozzle becoming clogged so that you will not need to remove it. Although made from durable, high-quality materials, this part is small and finely engineered. Accidental damage caused by cross-threading, overtightening, dropping the airbrush, forcing the needle or tools into the nozzle and normal wear are not covered under the warranty. Replacement parts and a repair service are available.

Available separately is a specialised Iwata Nozzle Wrench tool for removing and replacing the nozzle. The Airbrush Company strongly advise that you do not use the basic conventional spanner provided in the airbrush box, but advise that you instead use the improved nozzle tool to ensure you get the right angle and torque without risk of over tightening. This can prevent expensive damage to nozzles.

This part fits the following models:

• Iwata HP-A airbrush
• Iwata HP-B airbrush
• Iwata HP-SB airbrush

This part optionally fits the following models:

• Iwata HP-BC airbrush
  if you also fit 0.2mm Nozzle Cap, Needle Cap
• Iwata HP-BC2 airbrush
  if you also fit 0.2mm Nozzle Cap, Needle Cap
• Iwata HP-C airbrush
  if you also fit 0.2mm Nozzle Cap, Needle Cap

Additional information